How to Build a Simple Brick Wall
Building a simple brick wall may seem daunting, but with the right tools, knowledge, and techniques, anyone can achieve a professional-looking result. This guide will walk you through the process, from planning to completion, ensuring you a successful and satisfying DIY project.
Depending on the wall's purpose, you may need to check local building codes and obtain necessary permits. Additionally, it's crucial to understand the materials and tools required for the job.
Planning and Preparing
Before you start, measure the area where the wall will be built. Ensure you have the correct length and height in mind, as well as the type of bricks required. Consider the load-bearing capacity of the bricks and the base on which you'll build.



Gather your materials and tools. You'll need bricks, mortar, trowel, level, tape measure, rubber gloves, safety glasses, and a wheelbarrow for easier transportation of your materials.
Site Preparation
The base on which you build is crucial for the wall's stability. Clear the site of any debris, then dig a trench slightly deeper and wider than the wall's intended width. Ensure the base is level and well-compacted.



Pour a layer of concrete into the trench, creating a solid foundation for your wall. Allow it to cure according to the manufacturer's instructions before proceeding.
Mixing Mortar
Mortar is the mixture that binds your bricks together. It's typically made of three parts sand to one part cement. You can also buy ready-made mortar mixes for convenience.
Use a wheelbarrow or a large container to mix your mortar. Wet the sand first, then slowly add cement, mixing thoroughly until a consistent, workable consistency is achieved. Add water gradually to maintain the correct consistency.





Building the Wall
Start at one corner, laying a brick on its side to create a straight edge. Use your level to ensure it's perfectly vertical. Apply mortar to the brick's underside and sides using your trowel.
Start the first row, laying bricks with their ends against the corner brick. Leave a space between bricks to allow for expansion, known as a 'joint'. Ensure each brick is level and plumb. Use a spirit level for this.
Laying the Rows
Continue laying bricks row by row, applying mortar to the underside and sides of each brick. Ensure each row is perfectly level and aligned with the one below it. Use your level continuously to monitor the wall's verticality.
Every few rows, insert a metal wall tie to secure the wall to the structure it's attached to. This ensures the wall remains stable and doesn't lean over time.
Finishing Touches
Once you've reached the desired height, apply a layer of mortar to the top of the wall. This will create a flat, even surface if you plan to lay a coping or capping stone on top.
Allow the mortar to dry and the wall to cure completely before applying any additional finishing touches. For aesthetics, you can point the wall by filling the joints with mortar, creating a neat, professional finish.
Congratulations! You've just built a simple brick wall that will add value and aesthetics to your home. Should you decide to expand your masonry skills, consider learning about build arches, laying patios, or building retaining walls. Cheers to your newfound skill!





