"Mastering ThermTRU: Your Step-by-Step Guide to Installing a Therma-Tru Door
Installing a Therma-Tru door can enhance your home's security, energy efficiency, and curb appeal. With a few essential tools and these step-by-step instructions, you can upgrade your entrance confidently.
Before you begin, ensure you have the correct door size and the necessary tools. This guide assumes you're replacing an existing door with a Therma-Tru door of the same size.
Preparation and Measurement
Start by measuring your existing door opening to ensure your new Therma-Tru door will fit perfectly. Measure the width, height, and thickness at multiple points to account for any variances in the frame.



Gather your tools: tape measure, pencil, circular saw (if needed), drill, screwdriver, hammer, level, shims, and safety gear (eye protection, work gloves, etc.).
Removing Your Existing Door
Begin by removing the existing door. Unscrew the hinges and, if necessary, cut the hinge pins with a hacksaw or use a hinge removal tool. Carefully take out the door and any remaining hardware.



Remove the interior trim and any remaining screws or nails from the door frame. Clean the area to make installation of your new Therma-Tru door smoother.
Installing the New Therma-Tru Door
Begin by laying the new Therma-Tru door flat on a stable surface. Attach the hinges to the door edge that will be on the hinge side of the frame. Ensure the hinges are level and evenly spaced.
Position the door in the opening, with the hinges facing the frame. Use shims to level the door both vertically and horizontally. Mark the screw holes, remove the door, and drill pilot holes for the screws.






Finishing Touches
Reinstall the door, securing it with screws through the hinges. Test the door's operation, ensuring it swings freely and latches securely.
A professional touch involves adding weatherstripping around the door's perimeter to ensure a tight seal. Measure and cut the weatherstripping, then attach it to the door's edge using the provided nails or adhesive.
Installing the Door Handle and Lockset
Install the exterior handle and lockset first. Mark and drill holes for the lockset, then insert the latch on the edge of the door. Attach the exterior handle and lockset hardware using the provided screws.

Repeat the process for the interior handle and lockset. Ensure both sides function correctly and are aligned precisely for smooth operation.
Installing the Threshold and Exterior Trim
Install the new threshold at the base of the door, securing it with the provided screws. Ensure the threshold is level and provides a proper seal against the door bottom.
Attach the exterior trim, if included, using finishing nails. Ensure the trim is level and evenly spaced, giving your door frame a polished finish.
Stand back and admire your new Therma-Tru door. Regularly inspect your door's operation and seals to ensure it continues to perform at its best, keeping your home secure and energy-efficient.





