How to Install Frost King Magnetic Door Seal
Installing a Frost King magnetic door seal is a valuable upgrade for your home. Not only does it provide a tight seal against drafts, but it also helps save on energy bills. This straightforward guide will walk you through the process, ensuring your installation is efficient and effective.
The Frost King magnetic door seal is a versatile and easy-to-install product. Before you start, gather your tools: a tape measure, a pencil, a level, a utility knife, and your new magnetic door seal. Also, ensure your door is a suitable candidate for this seal - it should be lightweight and not have any obstructions that could interfere with the seal's operation.
Pre-Installation Planning
Accurate measurement is key to a perfect fit. Before you start, measure the width of your door. The Frost King seal is available in various sizes to suit different door widths.



Next, decide on the installation location. The seal should be installed near the bottom of the door, allowing it to contact the threshold and create a tight seal. Ensure the installation area is clean and free of any obstructions.
Marking the Installation Area
Using your tape measure and pencil, mark the top and bottom installation points on the door. These marks should be level with each other. A Spirit level ensures accurate and consistent marking.



For double doors, align the marks on both door leaves. The Frost King seal can adjust to fit the expansion and contraction of double doors, maintaining a consistent seal.
Attaching the Seal
Unwrap the Frost King seal and position it over the marks. Align the top and bottom edges of the seal with the marks you've made, ensuring it is level.
Now, peel the protective backing from the adhesive strip on the seal. Press the seal firmly against the door, holding it in place for 30 seconds to ensure a strong bond. Use the entire length of the seal to create a continuous, airtight seal against drafts.






Post-Installation Checks
After the seal is attached, perform a quick check to ensure it's properly installed. Swing the door open and closed a few times to allow the magnetic strips to connect and disconnect smoothly.
Inspect the seal's position. It should align consistently with the threshold, creating a tight seal when the door is closed. Adjust the position if necessary for a perfect fit.
Testing the Seal
With the door closed, run your hand along the bottom edge to check for any gaps. If you feel any drafts, adjust the door's position or the seal's alignment until you achieve a tight seal.

Turn your overheard lights on and observe the edge of the door. If light is visible, the seal might not be creating a complete barrier. Make adjustments until the light is completely blocked, indicating a successful seal.
Your Frost King magnetic door seal is now installed and ready to keep drafts out and energy bills low. Regular checks and maintenance will ensure its longevity and effectiveness. Enjoy the comfort of a draft-free home!




