How to Put Baseboards Back In
When moving or renovating, baseboards are often removed and left laying around. Reinstalling baseboards might seem daunting, but with the right tools and steps, you can have them back in place in no time. This guide will walk you through the process, from gathering tools to the final touches, ensuring your space looks cohesive and well-maintained.
Before you start, ensure you're working with the correct tools to save time and effort. The basic tools needed include a miter saw, tape measure, pencil, coping saw (for cutting inside corners), finish nailer, Brad's nailer, sandpaper (120-grit and 220-grit), paint or stain, and caulk. Having these at hand will streamline the process of putting baseboards back in.
Preparation and Measuring
Thorough preparation is key to a successful reinstallation. Begin by ensuring your walls are clean and free of dust. Next, lay out all your baseboard pieces in the room to visualize how they'll fit together. This step is crucial for cutting precise pieces for both wall-to-wall and corner-to-corner fits.



Measure each wall accurately, accounting for any peculiarities or irregularities. Your measurements should include the distance from the floor to the top of the baseboard. This step might seem tedious, but accurate measurements ensure a seamless, professional-looking finish.
Cutting Baseboard Pieces
Use a miter saw to cut baseboard pieces at 45-degree angles for outside corners. Mark your cutting line on the piece's face side, ensuring your cut follows the top edge. For inside corners, use a coping saw to create a cope joint, allowing one piece to wrap around the other neatly. Always make test cuts on scrap wood to perfect your technique before cutting final pieces.



When cutting long straight pieces, use a Brad's nailer to secure them to a flat surface, and cut into your saw's fence. This technique prevents any rocking or twisting during the cut, ensuring clean, precise results. Double-check measurements and marks before making any cuts to avoid wastage.
Installing Baseboards
Start in a corner and work your way around the room. Apply construction adhesive evenly along the back of the baseboard, about an inch from the top corner. This adhesive helps hold the baseboard in place and adds stability. Begin nailing using a finish nailer, spacing the nails about 16 to 24 inches apart and approximately 1/2 inch up from the baseboard's bottom edge. Ensure nails are driven flush with the surface to prevent any protrusions.
Use a Brad's nailer to install scarf joints where two pieces meet. Drive nails at an angle, spacing them evenly and avoiding any previous nail holes. Always check the fit of your pieces by holding them up to the wall and making any adjustments before nailing them in place.






Finishing Touches
Once all baseboards are securely installed, sand any rough edges or nail holes using 120-grit sandpaper. Dust off the surface before switching to 220-grit sandpaper for a smooth, smooth finish. Apply paint or stain, following the manufacturer's instructions for application and drying times. Allow the baseboards to dry completely before walking on or placing furniture against them.
Finally, use a paintable caulk to fill any gaps between the baseboard and the wall. Run a continuous bead along the seam, then use a damp cloth or your finger to smooth and remove excess caulk. Allow it to dry completely, then paint over it to match your wall color.
Reinstalling baseboards might seem like a challenging task, but with the right tools and these detailed steps, you'll have your space looking polished and well-finished in no time. Happy renovations!






