DIY Tile Coasters: Easy & Stylish Craft Ideas
Ever looked at your tiles and thought, "These are too nice to just be on the floor"? Making tile coasters is a fun, eco-friendly, and practical way to upcycle those spare tiles lying around. Here's a comprehensive guide on how to turn your tiles into functional art pieces.
Before you start, make sure you've got some basic materials ready. This includes your tiles, tile adhesive, grout, sandpaper, sealant, and some basic tools like a trowel, grout float, sponge, and safety equipment like gloves and goggles.
Preparing Your Tiles
Start by sorting through your tiles. Make sure they're clean and free of any defects that might make them unsuitable for coasters.



Next, it's time to sand their surfaces. This not only smooths out any rough edges but also etches the surface slightly, improving adhesion for the adhesive and grout. Use medium grit sandpaper, sanding lightly in one direction to avoid scratching.
Adhesive and Grout Selection
Choose an adhesive that's suitable for your tile type. For ceramic or natural stone tiles, a flexible and strong adhesive like a polymer-modified cement-based adhesive is a good choice.



The grout you choose should complement your tile color. Diagnostic colored grouts or unsanded grout may be the best options for small tiles like those on coasters. Always follow the manufacturer's instruction for mixing and application.
Tile Adhesive Application
Begin by spreading the adhesive onto the back of your tile using a notched trowel. Start in the middle of the tile, then spread it out towards the edges with the flat edge of the trowel.
Once the back of the tile is covered, lightly press it onto the pallet or board you're using to create your coasters. Use clamps or weights to hold it in place until the adhesive sets, according to the manufacturer's instructions.






Applying Grout
Once the adhesive is completely dry, mix your grout according to the package instructions. Use a grout float to spread the grout diagonally across the tile surface, pressing it firmly into the joints.
Allow the grout to set for 10-15 minutes, then use a damp sponge to remove any excess grout from the tile surface. Rinse and wring out your sponge frequently to avoid spreading grout onto the tile face. Let the grout cure according to the manufacturer's instructions.
Final Touches
After the grout has fully cured, use fine-grit sandpaper to lightly sand any rough spots on the grout lines. Vacuum up any dust and wipe the tile clean.

Now it's time to apply a sealant. This helps to protect the tile and grout from staining and moisture. Use a foam applicator to evenly spread a thin coat of sealant onto the tile surface. After it dries, apply a second coat for best protection.
Once the sealant is completely dry, your tile coasters are ready to use! They add a unique decorative touch to any table, while keeping surfaces safe from heat and moisture. Don't forget, they make great gifts too, so why not make a batch to share? Now go ahead, unleash your creativity with those spare tiles!





