Maytag Dryer Motor Replacement: Step-by-Step Guide
Is your Maytag dryer on the fritz? A faulty motor could be the culprit. While replacing a dryer motor might seem daunting, this guide will walk you through the process, ensuring a successful Maytag dryer motor replacement. Let's dive in and get your dryer back up and running in no time.
Before we begin, safety first! Unplug your dryer, turn off the gas supply valve if applicable, and allow the dryer to cool down to prevent any injuries. Now, let's gather your tools: a Phillips screwdriver, 1/4" nut driver, and a pair of safety glasses. You might also need a new motor, which you can source from reputable retailers or directly from Maytag.
Diagnosing the Problem
Before rushing into a motor replacement, let's confirm the motor is indeed the issue. Check for the following symptoms:



- Dryer won't start or spin. - Dryer spins slowly or stops mid-cycle. - Burning smell or unusual noises coming from the dryer.
Testing the Motor
To test the motor, grab a multimeter and follow these steps:



- Remove the back panel of the dryer.
- Locate the motor.
- Set your multimeter to Ohms (Ω) and measure the resistance between the motor's two terminals. Make sure the dryer is unplugged and the motor isn't connected to anything!
- Compare your reading to the motor's datasheet. If the resistance is too high or too low, you've got a faulty motor on your hands.
Obtaining a Replacement Motor
Once you've confirmed the motor needs replacing, ensure you get the correct model. Use your Maytag dryer's model number to find the compatible motor. You can usually find this number on a plate located in the dryer's back, top, or inside the door.
Now that you have your new motor, let's get ready for the Maytag dryer motor replacement.
Replacing the Motor
With your tools and new motor at hand, let's proceed with the replacement. The exact process may vary slightly depending on your dryer model, so always consult your owner's manual for specific instructions.






Dismantling the Dryer
Begin by disconnecting the exhaust pipe from the dryer. Then, remove the dryer's rear access panel, usually secured with screws. Disconnect the electrical wires connected to the existing motor, carefully labeling each wire's location for reassembly later on.
Unbolt the motor from theaphore mount using a 1/4" nut driver. With the motor now free, pull it out, remembering to disconnect any belts or drives attached to it.
Installing the New Motor
Reverse the dismantling process with your new motor:

- Reconnect the belts or drives, ensuring they're properly aligned.
- Secure the new motor to the aphore mount using the provided bolts.
- Reconnect the electrical wires, ensuring they match the labels you created earlier.
- Reattach the exhaust pipe and the rear access panel.
Testing the Dryer
Once everything is back in place, it's time to test your Maytag dryer:
- Plug in the dryer and ensure all the control panel lights and display are functioning correctly.
- Run a test cycle to check if the dryer spins and heats up appropriately.
- Inspect the motor housing for any signs of overheating after the test cycle.
Congratulations! You've successfully completed your Maytag dryer motor replacement. Now, you can enjoy clean, dry clothes once again. Should you encounter any issues or prefer professional help, don't hesitate to contact a certified technician. Happy drying!





