How to Remove Maytag Washer Top Plate: A Simple Step-by-Step Guide
Doing your laundry is a breeze with Maytag's reliable and durable washers. However, there may come a time when removing the wash plate or agitator becomes necessary, perhaps for cleaning or repair needs. This guide walks you through a simple and safe process of removing the wash plate from your Maytag washer.
Before you start, ensure that the washer is empty and unplugged from the power source. Also, gather some essential tools like a putty knife, flathead screwdriver, and possibly some pliers. Let's dive into the step-by-step process.
Preparing the Washer for Wash Plate Removal
Begin by removing any remaining laundry and debris from the washer tub to make your task easier and safer.



Next, take out the screws that secure the control panel. These are usually located at the bottom of the panel. Once the screws are out, gently lift the panel up and away from the washer. Sometimes, you might need to disconnect a few wires carefully and set the panel aside.
Accessing the Wash Plate
With the control panel removed, you should have clear access to the washer's internal components. You'll see the wash plate, also known as the agitator, in the center of the tub.



Before attempting to remove the wash plate, make sure the washer is level. If not, you might need to adjust the washer's feet to ensure it's sitting evenly on the floor. This will make removal and re-installation smoother.
Removing the Wash Plate
The Maytag wash plate is designed to be removed without tools, but if it's stuck, you might need to use a putty knife or a flathead screwdriver. Insert the tool into the small gap between the wash plate and the tub. Carefully pry the wash plate away from the tub, making sure to apply even pressure.
Once you've created enough space, you should be able to grasp the wash plate and gently pull it straight up and out of the tub. If it's still not budging, try rotating the wash plate back and forth to break the suction and facilitate removal.






Cleaning and Maintaining Your Wash Plate
Now that you've successfully removed the wash plate, it's a good idea to give it a thorough cleaning. Even if you empty the lint trap and clean the washer regularly, a buildup of detergent residue, fabric softener, and other debris can occur over time.
Use a liberal amount of dish soap and hot water, then scrub the wash plate with a stiff-bristled brush. Let it soak for about 15 minutes, then scrub again and rinse thoroughly. Inspect the wash plate for any signs of damage or wear, and address any issues promptly to maintain the washer's optimal performance.
Re-Installing the Wash Plate
After cleaning, re-installing the wash plate is essentially the reverse process of removal. Align the wash plate with the center post in the washer tub, and then gently press down and turn it clockwise to secure it into place. Make sure it's firmly seated and fully secured before replacing the control panel.

Once the wash plate is reinstalled, replace the control panel and reattach any wires you disconnected earlier. Secure the panel in place with the screws you removed initially. Finally, plug the washer back in and test it to ensure everything is working correctly.
Regularly removing and cleaning the wash plate from your Maytag washer can help maintain its performance and extend its lifespan. If you're unsure about any steps or encounter difficulties, don't hesitate to consult a professional repair technician for assistance. Happy cleaning!




