Wiring Diagram: Outlet to Switch to Light
Ever found yourself in a pitch-black room, fumbling for the light switch in the dark? It's inconvenient, to say the least. Wouldn't it be great if you could turn on the lights from another room, or even install a motion sensor for hands-free lighting? This is where wiring a switch to an outlet comes into play. Let's explore how to achieve this, step by step.
First, let's understand the basic idea. We're going to wire an outlet so that it can control the power flowing to a switch. When you flip the switch on, the outlet will activate and provide power to your lights or other appliances. Here's how to do it.
Gathering Materials and Understanding the Wiring
Before you start, ensure you have the following materials: a non-contact voltage tester, electrical tape, needle-nose pliers, wire stripper, two outlets, two switches, 14/3 non-metallicsheathed cable (Romex), 14/2 non-metallic sheathed cable (Romex), and a junction box.



The 14/3 cable has three wires (black, white, and ground), while the 14/2 has two (black and white, with the ground being the outer metallic sheath). We'll use the 14/3 to connect the switch and outlet, and the 14/2 for the power source.
Wiring the Switch
Let's start with the switch. Strip about 1.5 inches of insulation off both ends of the 14/3 cable. Then, connect the black and white wires to the switch as follows:



- Attach the black wire to the brass-colored screw (hot).
- Attach the white wire to the silver-colored screw (neutral).
- The ground (green) wire can be attached to the green screw or the grounding clamp.
Make sure all wires are securely tightened and none of the wires are too long, with exposed copper visible after the wire nut.
Wiring the Outlet
At the outlet, connect the wires similarly:
- The black wire from the switch (which is actually the 'hot' wire carrying power) goes to the brass-colored screw.
- The white wire from the switch goes to the silver-colored screw.
- The ground (green) wire is attached to the green screw or grounding clamp.
- The 14/2 cable's hot (black) wire is connected to the brass-colored screw of the outlet.
- The 14/2 cable's neutral (white) wire is connected to the silver-colored screw.
- The 14/2 cable's ground (green) wire is attached to the green screw or grounding clamp.
The 14/3 cable's other end goes back to the switch, completing the circuit.






Testing and Installing
Testing the Wiring
Before screwing the outlets and switches into the wall, test your wiring to ensure everything is working as expected. Use your non-contact voltage tester to check for electricity:
- Ensure power is off at the circuit panel.
- Measure the wires at the switch and outlet to confirm there's no voltage.
- Turn the power back on at the panel.
- Measure again. The 'hot' wire at the outlet should now show voltage.
Installing the Outlet and Switch
Once you've double-checked that your wiring is correct, install the outlet and switch into the boxes, securing them with screws. Plug in a lamp or other appliance, and flick the switch. If everything is wired correctly, your light should turn on!
Always remember to turn off power at the circuit panel before starting any electrical work, and double-check your work to ensure it's safe. Enjoy your newfound convenience!





