2008 Chevy Impala Side Mirror Replacement: Easy DIY Guide & Parts List
Are you a proud owner of a 2008 Chevy Impala, butcurrently dealing with a broken side mirror? It's frustrating, we know. Replacing it might seem daunting, but we're here to help! We'll guide you through a step-by-step process to replace your side mirror like a pro. Let's dive in!
First, let's prepare for the task at hand. Before you start, you'll need a few tools and some time. You'll need a Ratchet socket wrench, a Socket extension if needed, a Flathead screwdriver, a Pliers, and a little patience. Also, ensure you have a new side mirror compatible with your 2008 Chevy Impala.
Removing the Old Side Mirror
Before you start, make sure your 2008 Chevy Impala is parked on a flat surface and engaged in gear or park to ensure no unwanted rolling.



Then, locate the bolts securing the mirror to the mirror housing. They're typically 10mm and can be accessed using a Ratchet socket wrench. Unscrew them counterclockwise, and they should come out with a bit of a twist.
Disconnecting the Electrical Wiring
With the bolts removed, gently pull the old mirror away from the mirror housing. You'll see electrical wires connected to the mirror. Before disconnecting, mark the wires using tape or color-coding to help you put everything back in its right place later.



Now, disconnect the wires one by one by squeezing the connectors and pulling them gently apart. If they're stuck, wiggle them gently while pulling.
Removing the Old Mirror Housing (if damaged)
If your mirror housing is damaged and needs replacement, you'll need to remove it. Use a Flathead screwdriver to gently pry off the housing. You might need to use some force, but be careful not to damage the car's body.
Once the housing is loose, remove it by wiggling it out. If there are any bolts or screws, they should be visible now and can be removed with the appropriate tool.




Installing the New Side Mirror
Now that the old mirror is out, it's time to install the new one. Make sure you have the correct mirror for your 2008 Chevy Impala. It's always a good idea to compare it with the old one to ensure it's the right fit.
If you're replacing just the mirror and not the housing, skip ahead to the 'Reconnecting the Electrical Wiring' section below.
Installing the New Mirror Housing (if damaged)
If you're replacing the entire housing, start by positioning the new housing onto the car's body. Align it carefully to ensure it fits snugly.
Once you're sure it's in the right place, use the Flathead screwdriver to lightly tap it into place. Ensure it's secure but not overtightened. If there are any bolts or screws, secure them using the Ratchet socket wrench.
Reconnecting the Electrical Wiring
Now, take the new mirror and reconnect the electrical wires. Match the colors and the marks you made earlier. press the connectors together firmly until they click into place.
Once all the wires are connected, position the mirror onto the housing and align the holes with the bolts.
Securing the New Side Mirror
With the mirror in place, use the Ratchet socket wrench to screw in the bolts clockwise. Tighten them securely but not too much to avoid damaging the threads.
Finally, give your new side mirror a gentle wiggle to ensure it's secure and ready to serve you well for years to come.
There you have it! You've successfully replaced your 2008 Chevy Impala's side mirror. Next time you hit the road, you'll do so with confidence and a clear view of what's beside you. Drive safe!





